 | | Re: NXT Firmware source code
|
|
(...) Not to put too fine a point on it, but the 100 cycle limit is only on the lock bits, I think. This is specified at the extreme limits of voltage and temperature. At normal room conditions, actual NXTs were reflashed (which cycles the lock (...) (18 years ago, 19-Dec-06, to lugnet.robotics.nxt)
|
| |
| | Re: NXT Firmware source code
|
|
"Steve Lane yahoo.co.uk>" <stevenrobertlane@<n...pamplease> wrote in message news:JABnK0.15z@lugnet.com... (...) Fortunately the most common failure mode is a reduction in the "longevity" of storage. Out of box, the Atmel ARM flash is specified to (...) (18 years ago, 18-Dec-06, to lugnet.robotics.nxt)
|
| |
| | Re: Has anyone figured out how to improve the NXT light sensor?
|
|
(...) Yes. I didn't end up using it because speed ended up being more critical than precision, but for narrow lines I may go back to it. I suspect I might be able to use it to follow lines drawn by a black marker. (...) No. Well, kind of. I used a (...) (18 years ago, 18-Dec-06, to lugnet.robotics.nxt)
|
| |
| | Re: NXT candid camera
|
|
(...) The second video is better, I think. Spike was always my favorite NXT robot. (18 years ago, 18-Dec-06, to lugnet.robotics.nxt, lugnet.mediawatch)
|
| |
| | Re: Has anyone figured out how to improve the NXT light sensor?
|
|
Hi Geoffrey, (...) Detecting 1x1 plates should not be hard if they pass close to fiber optic end to efficiently block light. (...) I believe it's caused by the blue background I used that somewhat fooled my camera white balance. That said there is a (...) (18 years ago, 18-Dec-06, to lugnet.robotics.nxt)
|
