 | | Re: Serial LED is not lighting up during charger board assembly —Rainer Balzerowski
|
| | | Hi Scott, as I mentioned before i only assembled some 6.270 boards, but no handyboard. So what's follwing is only what i guess. I can't check this out here. Are you able to measure (always with pin7 J9 as ground reference) +9V at pin2 U16 and -9V at (...) (23 years ago, 26-Aug-01, to lugnet.robotics.handyboard)
|
| | | |
| | | | | Re: Serial LED is not lighting up = pilot error —Scott Hazel
|
| | | | I believe I've determined the problem. It looks like pilot error. Upon closer inspection of the serial LED, I noticed that it was defintely backwards in comparison to the power LED. I know that the power LED works like it should so the serial LED (...) (23 years ago, 3-Sep-01, to lugnet.robotics.handyboard)
|
| | | | |
| | | | | | Re: Serial LED is not lighting up = pilot error —Rainer Balzerowski
|
| | | | Hi Scott, the handyboard part-list says that this LEDs are from the HLMP17xx series. These LEDs are low-current LEDs and only need 2 mA current at (1.8V) 1.9V forward voltage. So your 10mA 3V LEDs doesn't fit. Have a look at : (URL) you can use LEDs (...) (23 years ago, 3-Sep-01, to lugnet.robotics.handyboard)
|
| | | | |
