Subject:
|
Re: Serial connection to a basic stamp
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 19 Dec 2000 10:17:37 GMT
|
Viewed:
|
1319 times
|
| |
|
|
In lugnet.robotics.handyboard, Damian Trujillo writes:
Hi Damian,
at first you should tale a look at http://handyboard.com/software/serial.html
You should find the necessary information there.
Rainer
> My team and I are working on a robot which uses the Parallax Basic stamp 2e to
> drive all of the legs. We aer using the handy board to process all sensor
> signals and send the appropriate message to the basic stamp to do programmed
> leg movements. here is the problem; I have no idea how to create a serial
> connection from the handy board (we have the expansion board) going to the
> basic stamp. First of all how do I know which pin on (J10) to use. Secondly how
> would I code the handy board to send an 8-bit message over a wire to the basic
> stamp's input pin?
>
> Thank you folks,
> Damian
|
|
Message is in Reply To:
 | | Serial connection to a basic stamp
|
| Hello all, My team and I are working on a robot which uses the Parallax Basic stamp 2e to drive all of the legs. We aer using the handy board to process all sensor signals and send the appropriate message to the basic stamp to do programmed leg (...) (24 years ago, 19-Dec-00, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
