To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 7925
    Re: 6.8 nF Capacitor —Tom Napolitano
   (...) Yes. Capacitors have typically very loose tolerances anyhow; usually 20% unless you buy specifically selected samples in a tighter tolerance. The 6.8 is a standard value while the 6.6 you have is likely a specially selected non-standard value. (...) (24 years ago, 6-Jul-00, to lugnet.robotics.handyboard)
   
        Re: 6.8 nF Capacitor —John Hatton
   The 6.6nF was the capacitance measured for the two 6.8nF capacitors that I have managed to get (rated as 10% tolerance). The problem is that the parts listed for the HB are 2% tolerance 6.8nF capacitors which gives a lowest value of 6.6664nF which (...) (24 years ago, 6-Jul-00, to lugnet.robotics.handyboard)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR