 | | serial output —E158 (M.FAZAL)
|
| | | hi i want to send a byte as a series of bit to a transamitter module i am using. the FAQ says i can use the digital 9, or SPI port or TOC3. i can output to these ports. the first problem is getting the delay times between bits. if i use the msleep() (...) (25 years ago, 16-Feb-00, to lugnet.robotics.handyboard)
|
| | | |
| | | | | Re: serial output —Fred G. Martin
|
| | | | you're not going to be able to generate accurate bit times using Interactive C -- it'd have to be an assembly language driver. use the 9600 baud output driver located at (URL) your message you said: (...) (25 years ago, 16-Feb-00, to lugnet.robotics.handyboard)
|
| | | | |
| | | | | | Re: serial output —Fazal
|
| | | | My transmitter module can accept upto 1200 baud. can i modify this driver to run at 1200baud. if possible how? i dont really understant assembly code. could you also point me to a book or manual which gives assembler commands. many thanks M Fazal (...) (25 years ago, 16-Feb-00, to lugnet.robotics.handyboard)
|
| | | | |
