To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 7430
  serial output
 
hi i want to send a byte as a series of bit to a transamitter module i am using. the FAQ says i can use the digital 9, or SPI port or TOC3. i can output to these ports. the first problem is getting the delay times between bits. if i use the msleep() (...) (25 years ago, 16-Feb-00, to lugnet.robotics.handyboard)
 
  Re: serial output
 
you're not going to be able to generate accurate bit times using Interactive C -- it'd have to be an assembly language driver. use the 9600 baud output driver located at (URL) your message you said: (...) (25 years ago, 16-Feb-00, to lugnet.robotics.handyboard)
 
  Re: serial output
 
My transmitter module can accept upto 1200 baud. can i modify this driver to run at 1200baud. if possible how? i dont really understant assembly code. could you also point me to a book or manual which gives assembler commands. many thanks M Fazal (...) (25 years ago, 16-Feb-00, to lugnet.robotics.handyboard)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR