Subject:
|
Driving an L298 motor driver board
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 12 Dec 1999 17:18:16 GMT
|
Viewed:
|
845 times
|
| |
|
|
I'm trying to drive 2 larger DC motors that draw about 1A each. I am using
a L298 motor driver board that is sold by HVWTech. I would like to drive it
straight from the Handyboard and I'm wondering if I'm going about this
correctly.
Am I correct in thinking that I can run the signal straight from the motor
in on the l293 socket, straight into the appropriate socket or pin of the
l298 and get the same result ? I have tried this but have not been
successful.
Anyone interfaced these successfully, and willing to share their expertise?
;)
Jim Munro
<jimmn@xnet.com>
http://www.xnet.com/~jimmn/robotics.htm
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
