Subject:
|
I need two servo signals...
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 16 Feb 1996 07:59:43 GMT
|
Original-From:
|
Nathan Parker <ngparker@ucsd.{Spamcake}edu>
|
Viewed:
|
2117 times
|
| |
|
|
I really need two servo-out signals. I got one working
just fine with the standard servo code and output to digital
pin 9. I was thinking I could just adapt the servo code for
another port, but I don't know what other port I can use.
Currently, I don't need the motor outs. Can I use those?
From reading the 68HC11 book I didn't see any other digital
input that could be converted to outputs, besides A7.
Any ideas would be greatly appriciated.
-- Nathan Parker
p.s. I'm trying to control an RC-10 speed controller and
an RC-servo, at the same time.
To: ngparker@ucsd.edu (Nathan Parker)
Cc: handyboard@media.mit.edu
Subject: Re: I need two servo signals...
In-Reply-To: Your message of "Thu, 15 Feb 96 23:59:43 PST."
<v02130501ad49e3ea2992@[137.110.67.20]>
Date: Fri, 16 Feb 96 08:23:11 -0500
From: "Fred G. Martin" <fredm>
X-Mts: smtp
There's a timer line on the expansion header (TOC3). Use that; the
code should be very similar.
-Fred
> I really need two servo-out signals. I got one working
> just fine with the standard servo code and output to digital
> pin 9. I was thinking I could just adapt the servo code for
> another port, but I don't know what other port I can use.
> Currently, I don't need the motor outs. Can I use those?
> > From reading the 68HC11 book I didn't see any other digital
> input that could be converted to outputs, besides A7.
>
> Any ideas would be greatly appriciated.
>
> -- Nathan Parker
>
> p.s. I'm trying to control an RC-10 speed controller and
> an RC-servo, at the same time.
>
>
>
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
