Subject:
|
Expansion Board
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 16 Jun 1999 17:36:54 GMT
|
Original-From:
|
Ethan Getz <ethang3@hotmail.com(StopSpammers)>
|
Viewed:
|
835 times
|
| |
| |
Does anybody know how to get the expansions board servo outputs to work. I
tried calling the function but I'm not sure if I have the correct programs
loaded into the handyboard.
|
|
Message has 2 Replies: | | Re: Expansion Board
|
| Did you try something like init_servo0(1) {I'm not sure I got the syntax correctly}. It enables the specifice servo output to function. ---...--- ericson mar Robotics Consultant mar@cooper.edu (212)353-4356 Department of Mechanical Engineering The (...) (25 years ago, 16-Jun-99, to lugnet.robotics.handyboard)
| | | IC Bible?
|
| Where can I get the best IC manual there is? ___...___ Steve Wall Sir Sandford Fleming college Swall@flemingc.on.ca (25 years ago, 16-Jun-99, to lugnet.robotics.handyboard)
|
5 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|