Subject:
|
Re: MC34064
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 12 May 1999 07:55:46 GMT
|
Original-From:
|
Jeff Loeliger <r12110@email.sps.mot.com#AntiSpam#>
|
Viewed:
|
745 times
|
| |
| |
Daniel,
Okay, I dug up my old email:
> This is a warning for anyone considering using the Motorola MC34064 to replace
> the DS1233. I have just built a couple handyboards and I had some problems
> getting them working. I finally tracked the problem done to the LVI. I used
> the
> MC34064 instead of the DS1233 because I had some laying around. WARNING the
> pin
> out on the two is not the same:
>
> Pin DS1233 MC34064
> 1 GND *RESET
> 2 *RESET +5
> 3 +5 GND
>
> The MC34064 can be used but it must be rotated 120 degrees so that the signals
> will be correct.
sakar@servidor.unam.mx wrote:
>
> Can anybody tell me the pins config in the MC34064, because I am using the
> MC34064 as a susbtitute of the DS1233.
>
> Thanks
>
> Daniel
>
> ---------------------------------------------------------------------
> " `BETTER´ IS THE ENEMY OF `GOOD ENOUGH´"
> ---------------------------------------------------------------------
-- Jeff
__________________________________________________________________
\ Jeff Loeliger Motorola SPS \
\ mailto:r12110@email.sps.mot.com Systems Engineering Department\
\ phone: +44-1355-35-5400 Powertrain Systems Division \
\ fax : +44-1355-35-6300 East Kilbride, Scotland \
\ Motorola Internal: http://ncsg-euroweb.sps.mot.com/~r12110 \
\_________________________________________________________________\
|
|
Message is in Reply To:
| | MC34064
|
| Can anybody tell me the pins config in the MC34064, because I am using the MC34064 as a susbtitute of the DS1233. Thanks Daniel ---...--- " `BETTER´ IS THE ENEMY OF `GOOD ENOUGH´" ---...--- (25 years ago, 13-May-99, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|