Subject:
|
Re: DS1233
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 11 May 1999 14:57:01 GMT
|
Original-From:
|
Jeff Loeliger <r12110@email.spsAVOIDSPAM.mot.com>
|
Viewed:
|
542 times
|
| |
| |
Daniel,
You can use the Motorola 34064, I used it in both of the Handyboards I build.
***WARNING*** the Motorola 34064 and the Dallas Semiconductor DS1233-10 have
different pins out. They are both in 3 pin to-92 packages. I don't remember
which two pins need to be swapped (check the two data sheets). I put a small
peice of tubing over one of the pins so they did not touch each other.
It was really hard to find this problem after I build the boards without
swapping the pins :-).
sakar@servidor.unam.mx wrote:
>
> Does anybody know the motorola susbtitute for the (Dallas Semiconductor)
> DS1233-10, because in Mexico the DS1233-10 does not exists. And I can´t find
> it on the electronics books.
>
> Thanks for the help
>
> Daniel
>
> ---------------------------------------------------------------------
> " `BETTER´ IS THE ENEMY OF `GOOD ENOUGH´"
> ---------------------------------------------------------------------
-- Jeff
__________________________________________________________________
\ Jeff Loeliger Motorola SPS \
\ mailto:r12110@email.sps.mot.com Systems Engineering Department\
\ phone: +44-1355-35-5400 Powertrain Systems Division \
\ fax : +44-1355-35-6300 East Kilbride, Scotland \
\ Motorola Internal: http://ncsg-euroweb.sps.mot.com/~r12110 \
\_________________________________________________________________\
|
|
Message is in Reply To:
| | DS1233
|
| Does anybody know the motorola susbtitute for the (Dallas Semiconductor) DS1233-10, because in Mexico the DS1233-10 does not exists. And I can´t find it on the electronics books. Thanks for the help Daniel ---...--- " `BETTER´ IS THE ENEMY OF `GOOD (...) (25 years ago, 11-May-99, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|