Subject:
|
MAX232 Chip
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Wed, 24 Feb 1999 04:20:06 GMT
|
Original-From:
|
Guy M. Snodgrass <navyguy@ai=antispam=.mit.edu>
|
Viewed:
|
1184 times
|
| |
|
|
To all:
I am constructing my first Handy board. I am currently building the
interface board, but have hit a small 'snag'. While performing 'step 2',
installing capacitors and MAX232, and then testing, I did not recieve the
correct voltage outputs. Any ideas? I checked the capacitor polarity and
the MAX232 seems installed properly? Perhaps a bad chip? If so, can I
sub a MAX233 I have here in the lab?
Thanks,
gms
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
