To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 5600
5599  |  5601
Subject: 
Expansion Board Problem
Newsgroups: 
lugnet.robotics.handyboard
Date: 
Sun, 21 Feb 1999 18:32:13 GMT
Original-From: 
James Plourde <JPLOURDE@saynotospamWVU.EDU>
Viewed: 
1176 times
  
We assembled the HandyBoard ourselves and everything seemed to go great.
However, the new set of analog inputs does not seem to be reading in values
correctly.  The input always seems to be stuck at 250 (The handyboards
inputs still work fine.)  I've checked the digital ports on the expansion
board and they work fine.  Is there a separate connection for the expansion
board besides where it plugs into the old LCD ports???

Thanks
James



Message has 1 Reply:
  Re: Expansion Board Problem
 
Yes there are two four pin connector along the fornt edge of the expansion board that connect to J13 and J8 on HB, one 8 pin (2 rows of four) that connects to jumper J6 on the HB and one 10 pin that plugs into the expansion bus J3 on the HB. Hope (...) (26 years ago, 22-Feb-99, to lugnet.robotics.handyboard)

2 Messages in This Thread:

Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    

Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR