To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 5501
    shaft encoders for a track drive —Steve Wall
   Has anybody out there constructed shaft encoders for a track driven MOBOT. If any body has I would appreciate any help you could give me. I wasn't going to use shaft encoders but I guess they are needed for many things correct? Is there anyway to (...) (26 years ago, 15-Feb-99, to lugnet.robotics.handyboard)
   
        Re: shaft encoders for a track drive —Will Bain
   Steve Wall wrote: <snip> (...) I've had good results using Hall effect magnetic sensors. I found some 0.1" dia. disk magnets at the hobby shop and embedded them into the holes in some Lego Technic pulley wheels. It's true that only about three (...) (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR