Subject:
|
RE: Expansion board assembly tips?
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 11 Feb 1999 15:11:17 GMT
|
Original-From:
|
brett anthony <anthonyb@ecs+stopspammers+.csus.edu>
|
Viewed:
|
1113 times
|
| |
|
|
Before you do anything else, I would suggest cut to length the male headers
which interconnect with the HandyBoard, and plug them into the appropriate
sockets on the HB. Note that the mating pins are too long to insert fully
into the sockets. This is by design. Fit the Exp board to the solder
tails, and solder from the top. You may have to do some judicious bending
of the female sockets on the HB to make it line up.
Brett Anthony
Equipment Technician
College of Engineering and Computer Science
California State University, Sacramento
Postal Mail: Brett Anthony
CSUS, E&CS
6000 J St.
Sacramento, CA 95819-6023
email: anthonyb@ecs.csus.edu
phone: (916)278-6253
fax: (916)278-5949
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
