Subject:
|
Re: CONTINUOUS BEEPING
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 22 Jan 1999 23:11:06 GMT
|
Original-From:
|
K.L.McKinnon <"klmckin@nospam"@magmacom.com/spamcake/>
|
Viewed:
|
1012 times
|
| |
|
|
I would suspect that the system locks up without the LCD. There is a
PCODE out there for use without the LCD panel, and I believe that it is
at the handyboard web site.
K.L. McKinnon
SHETTI.NITIN.MANGESH wrote:
>
> Dear Fred Martin/friends,
> We have put a total of 6 chips on the handy board-the 6811 ,two
> chips placed side by side to the left of the 6811, the fat chip on the
> upper side of the 6811, two ICs(chips) one on each side of the fat
> chip.(component side) Please mind my language, I have not done the
> soldering and hence I don't know the chip nos.
> The pcode_hb.s19 file downloads fine but when we reset the board
> the speaker beeps continously and IC does not boot up.
> Please tell me what could be the problem and its solution?
> Thanking you, Yours Sincerely,
> Nitin
|
|
Message is in Reply To:
 | | CONTINUOUS BEEPING
|
| Dear Fred Martin/friends, We have put a total of 6 chips on the handy board-the 6811 ,two chips placed side by side to the left of the 6811, the fat chip on the upper side of the 6811, two ICs(chips) one on each side of the fat chip.(component side) (...) (26 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
