To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 52
  Can't initialize CONFIG register
 
Hello, Everyone: Help! I'm trying to configure the HB. Here's what I get: C:\IC> dlm config0c.s19 -port COM2 -eeprom DLM: 6811 File Downloader... etc. Using COM2 Downloading to EEPROM Downloading config0c.s19, press ESC to abort Downloading eeprom (...) (29 years ago, 11-Feb-96, to lugnet.robotics.handyboard)
 
  Re: Can't initialize CONFIG register
 
In your message you said: (...) ok. the dlm *is* trying to write the one byte, because the config reg lives at 0x103f. and it's trying to write it as 0x0c, which is also correct. but apparently it is not working, b/c you say that when you run the (...) (29 years ago, 12-Feb-96, to lugnet.robotics.handyboard)

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR