Subject:
|
Re: LCD configs (was:Suppliers and rf link)
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sat, 19 Dec 1998 14:57:33 GMT
|
Original-From:
|
FTHOMPSON9@AOL.COMstopspammers
|
Viewed:
|
1102 times
|
| |
|
|
john calhoun,
Mine just arrived and they are 1 X 16 connectors. I ordered 2035TNLD/Y
displays for $8.00 each. You might want to order now while they have the 2X16
displays with 1X16 connectors.
I have soldered the connector on and tested it and its works fine.
Good Luck,
Pherd
In a message dated 98-12-12 13:59:16 EST, you write:
<<
> Nuts & Volts magazine caries lots of adds for just the sort of thing you
>need (www.nutsvolts.com). I wanted to mention here the 2 X 16 and 2 X 20
LCD
>displays which are on sale for $8.00 each at
>www.flat-panel.com.
I just wanted to voice a warning of sorts. I ordered the 2 X 16 LCD from
them and the pinout is slightly different. Instead of a single line of
14 pins:
x x x x x x x x x x x x x x
They come with a dual inline 2x7 pin configuration:
x x x x x x x
x x x x x x x
I believe they're compatible otherwise. But you will have to make a
rather nasty cable to connect the LCD to the Handyboard.
Perhaps someone could make a board with tracings and pin headers (male)
that would connect the two - a sort of sandwich of sorts. The 2x7 pin
out seems to be fairly common these days. Perhaps even the new
"expansion board" that Fred and company are working on could contain an
alternate pinout for 2x7 LCDs.
john calhoun-
>>
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
