Subject:
|
Re: Servos for the miniboard
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 10 Dec 1998 23:32:11 GMT
|
Original-From:
|
richs@imssys.imssys.IHATESPAMcom
|
Viewed:
|
1148 times
|
| |
| |
Jonathan,
I would probably go with a futaba servo. I dunno how much torque
you need, but for a small(up to .30 cubic inch displacement, maybe even
.60) engine, the s148 does the job quite nicely. Tower hobbies sells
them for $14, and they can be controlled by the standard servo routines
that come in the miniboard library...
Jon
|
|
Message is in Reply To:
| | Servos for the miniboard
|
| I would like to use a servo to operate the throttle of a small gas engine. I am planning on using the miniboard to control the servo. Are there any brands to avoid? Are there any brands that are far better than the rest? Will just about any RC servo (...) (26 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|