Subject:
|
start_process() questions
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Mon, 7 Dec 1998 19:29:13 GMT
|
Original-From:
|
Shiva Sinha <sinha@wam.{Spamcake}umd.edu>
|
Viewed:
|
1412 times
|
| |
|
|
Hi,
I'm using start_process() to run a set of processes. My questions() are:
1. does start_process() re-initailize all the called process's (local)
variables every time it calls the process?
2. If the process does not complete before its alloted time, does it
continue from where it ended (from the previous call), or start at the
beginning again?
I ask these questions because I have code that runs normally for the first
few seconds, then suddenly goes through the processes much faster.
Thanks,
Shiva Sinha
|
|
Message is in Reply To:
 | | Re: Good 9V motor source -Reply
|
| These motors are exellent quality and very powerful the gears are metal and the motors does not exed 300 mA @12V stalled. I currently use the same motors on my robot and had no problems at all. I drive them using the motor drivers on the Handy Board (...) (26 years ago, 30-Nov-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
