 | | how to adapt a voltage signal?
|
| greetings to all i dont know if it has been asked before, but im trying to use son extra ADCs on my handyboard, trouble is they have a 0 to 5V range (analogue) but im trying to adapt the signals in the ranges of 0 to 50 volts, how do i make them (...) (26 years ago, 13-Nov-98, to lugnet.robotics.handyboard)
| | | | | Re: how to adapt a voltage signal?
|
| You could use resistors to make a 1/10 voltage divider. If you need high input impeadance, you could build an Op-Amp circuit to divide the voltage by 10. Most ADC chips have a pin that is the reference voltage for the high end of the scale--set this (...) (26 years ago, 13-Nov-98, to lugnet.robotics.handyboard)
| |
