Subject:
|
Dead HB
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 22 Oct 1998 11:33:17 GMT
|
Original-From:
|
Mark Limb <S003348@STUDENT.UQ.EDUspamcake.AU>
|
Viewed:
|
1522 times
|
| |
| |
Hi All,
While I was building my sumo robot I managed to short a wire in my HB.
I put a wire that was connected to a multimeter and also connected to
another part of the robot, into a digital sensor input, sparks came out
and it smelt like burnt electronics. I checked over the board and there
was no physical damage that I could see. I downloaded IC and when I
reset it didn't say "Welcome to interactive c blah blah blah", like it
usually does, the LCD just stayed the same, all full bars on top row and
all clear on the bottom. There is obviously something wrong and I was
wondering if anyone may know of any quick tests or fixes for this sort
of problem. Thanks for any help
Joshua Wherrett
|
|
Message has 2 Replies: | | Re: Dead HB
|
| Well maybe you should try replacing the HC11 for a start.. These things tend to spoil easily and for no apparent reason.... :( (or is it just bad luck?) That's funny, you shorted out something and it still can download? Maybe you should also change (...) (26 years ago, 22-Oct-98, to lugnet.robotics.handyboard)
| | | Re: Dead HB
|
| Sounds like a lot of it is still up and running if you can download. I'd suggest going through the assembly instructions and performing the tests at the end of each section. You should, thereby, be able to isolate smaller areas that may be fried and (...) (26 years ago, 22-Oct-98, to lugnet.robotics.handyboard)
|
5 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|