Subject:
|
Config register 0x3c
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 17 Jul 1998 16:15:43 GMT
|
Original-From:
|
Skye Legon <slegon@/saynotospam/watfast.uwaterloo.ca>
|
Viewed:
|
1186 times
|
| |
| |
As no one has any insight into why I'm getting a config register value
of 0x3c when downloading pcode, I am into speculation mode.
To refresh people's memory: All of DL, DLM, and HBDL refuse to download
the pcode to my chip, and HBDL reports that my config register is set
to 0x3c. I have replaced my HC11 with a new one, and still get 0x3c.
Three questions then:
1. As the error occurs when I begin to write to RAM, is it possible that
I have a bad RAM chip, and this returned config register value of 0x3c
is somehow a result of that?
2. Is there any other bit of hardware on the board that could poop out and
result in HBDL returning a config register value of 0x3c?
3. Are there *any* suggestions for diagnostic tests I could perform to
track down this error?
Cheers, Skye.
+-----------------------------------------+----------------------------+
| Skye Legon | University of Waterloo |
| Systems Design Engineering | __/ __/ __/ __/ |
| Pattern Analysis & Machine Intelligence | __/ __/ __/ __/ __/ |
| 143 Columbia St. West, Unit E-4 | __/ __/ __/ ____/ __/ |
| Waterloo Ontario CANADA N2L 3L2 | __/__/__/ __/__/\__/__/ |
| +1(519)888-9249 | ______/ ___/ \___/ |
| slegon@uwaterloo.ca | DC 2620, 888-4567 x5192 |
+-----------------------------------------+----------------------------+
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|