Subject:
|
Polaroid 6500
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 26 May 1996 18:25:39 GMT
|
Original-From:
|
jluijk <jluijk@wxs.#nospam#net>
|
Viewed:
|
540 times
|
| |
| |
Hi,
I am trying to install the polaroid 6500.
I use the schematics I found with the sonar.c file at this site.
It doesn't work, I dont understand the Motor power connection why does
it have 4 pins ?
One motor only uses 3 pins ?
I think the sonar device doesnt get enough voltage, I only measure
around 0.5 volts ?
Does the striped side of the ribbon-cable goes in number 1 of the socket
on the polaroid board ? (etc. etc.).
Who can help me and give me some tips and tricks ?
I really want to see this thing working !
Thanks,
Jan Luijk.
|
|
Message has 1 Reply: | | Re: Polaroid 6500
|
| jluijk wrote: <snip> (...) The two on the left are + battery voltage and the two on the right are ground. They're doubled up to handle more current, I guess. (...) Make sure that you're getting 9.6 V at the motor power header, and that you have your (...) (26 years ago, 27-May-98, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|