Subject:
|
Addresses of SPI ports
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Tue, 19 May 1998 20:00:04 GMT
|
Original-From:
|
Arthur Tretyak <atr188@merle.acns.NOMORESPAMnwu.edu>
|
Viewed:
|
2087 times
|
| |
|
|
Hello. I was wondering if anyone knows all 4 addresses for all 4 ports of
SPI header. Thank you
--
*************************************
* Arthur Tretyak *
* or just Arturchik *
* a-tretyak@nwu.edu *
*************************************
|
|
Message has 2 Replies:
 | | Re: Addresses of SPI ports
|
| Hi The SPI Header is connected to port D of the hc11 as follows: Port D Bit 2 - PD2 - MISO Port D Bit 3 - PD3 - MOSI Port D Bit 4 - PD4 - SCK Port D Bit 5 - PD5 - SS All of those pins can be used for general-purpose I/O signals. To program port D (...) (27 years ago, 20-May-98, to lugnet.robotics.handyboard)
| | | Re: Addresses of SPI ports
|
| Hi Arthur, The SPI expansion header is shown below: ---...--- Pinouts: 1 Gnd | 2 | 1 | 2 Vcc 5V | 4 | 3 | 3 SS* | 6 | 5 | 4 MISO | 8 | 7 | 5 SCK ---...--- 6 MOSI 7 & 8 Not connected I assume you will be using the Handy Board as a MASTER device not a (...) (27 years ago, 20-May-98, to lugnet.robotics.handyboard)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
