Subject:
|
Re: how to use IR recievers?
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sat, 7 Mar 1998 19:10:17 GMT
|
Original-From:
|
Will Bain <willbain@cs.umt+spamcake+.edu>
|
Viewed:
|
1433 times
|
| |
| |
At 11:12 PM 3/6/98 -0800, patrick wrote:
(snip)
> So I dismembered a dead vcr and got the ir receiver module out, it consists
> of a pcb with a surface mounted 8-pin IC & a few resistors, a capacitor,
> and the ir sensitive device. It has three pins on it, obviously for
> signal, ground and supply voltage, I got the ground pegged, it's pretty
> obvious, but the other two just go to a couple of the pins of the IC.
> Anyone out there know how I can identify the other two?
If the VCR isn't totally dead, maybe you could plug in what's left of it and
probe the leads that used to go to the IR module for a live one?
(snip)
> ( I have the remote from the vcr, I expect to tear that apart to use its
> ir led.)
The HB comes with a modulated IR beacon port (right next to the modulated IR
receiver). I don't know how it works, but it looks like it's probably
similar to how the IR beacon on the 6270 board works.
If the VCR remote still works, though, why not use more of it than just the
IR LED? Why not use the modulator that's built into it? Then you'll know
it's at the correct frequency and sending the correct signal format.
--Will
, ,
__@_/ \_@__ |/
| /__, o @_/
)\ ) ( \ (\/\\,
~~~~~~~~~ ' ` ~~~~~~~~~~~ ` ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Wendy Parson, Few things are harder to put up with
Will Bain, than the annoyance of a good example.
& Tatoosh --Mark Twain
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|