Subject:
|
RE: Expanding the memory of the handyboard
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Thu, 19 Feb 1998 01:34:28 GMT
|
Original-From:
|
Kevin B. Smith <kbsmith@et.byu.edu[IHateSpam]>
|
Viewed:
|
1471 times
|
| |
| |
We used OEM barcode reader (IS4120-41 scanner decode engine) from
Metrologic Instruments, Inc..
The output of this reader is the barcode ASCII format transmitted across an
RS232 line. We read this with the handy board's RS232 serial port. You
can slow down the data transmission on the barcode reader so that you do
not have to use interrupt driven software on the handyboard's side.
However, in our competition seeing the barcode was frequently an
asynchronous event and an interrupt driven approach worked the best. They
are only about an 1.5"x1.5"x0.5" in size and they worked great. The
address for the barcode reader supplier follows:
Contact: Susan Kiesel
Sales / Tech support
Metrologic Instruments, Inc.
Coles Road @ Route 42
BlackWood, New Jersey 08012
(609) 228-8200
(609) 228-6673
http://www.metrologic.com
I hope that helps.
Kevin
-----Original Message-----
From: Chris Osborn [SMTP:fozztexx@fozztexx.com]
Sent: Wednesday, February 18, 1998 12:56 PM
To: Kevin B. Smith
Cc: 'handyboard@media.mit.edu'
Subject: Re: Expanding the memory of the handyboard
On Feb. 16 98, 18:34 PST, "Kevin B. Smith" <kbsmith@et.byu.edu>
wrote:
> They determined the ID of the pallet from a barcode label.
How did the board read the barcode label? What equipment/algorithm
was used?
I've been screwing around with a train, and haven't really had any
luck with reading a barcode from the track as it passes over.
---
Chris Osborn FozzTexx Enterprises
707 226 7629 - Voice 2136 Coronado Ave.
707 253 3063 - Fax Napa, CA 94559
<fozztexx@fozztexx.com> <http://www.fozztexx.com/>
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|