Subject:
|
assembling I/C board
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Fri, 18 Jul 1997 20:13:47 GMT
|
Original-From:
|
Phethsavong Prachith <pprachit@student.umass.[spamless]edu>
|
Viewed:
|
665 times
|
| |
| |
Hi,
I've encountered some problems assembling the interface/charger board.
After installing the 16-pin socket for U16 and the capacitors and then
mounting the MAX232 chip, I then applied power to the board. But, the PWR
LED did not lit up and the voltage at pin2 of U16 did not read +10 volts.
I'm quite positive the orientation of the capacitors is correct.
The test to check the MAX232 chip's ability to transmit data did check out.
Anyone know what might be wrong?
thanks,
phet
|
|
Message has 1 Reply: | | Re: assembling I/C board
|
| (...) Well, if the power LED didn't light, then you don't have power to the MAX232 chip (unless the LED is installed backward or broken). It sounds like you've already skipped ahead without passing the first set of tests, which I've copied from the (...) (27 years ago, 19-Jul-97, to lugnet.robotics.handyboard)
|
2 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|