Subject:
|
Fried analog port
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 13 Apr 1997 22:45:57 GMT
|
Original-From:
|
Peter Eacmen <EACMEN@POSTOFFICE.WORLDNETnospam.ATT.NET>
|
Reply-To:
|
EACMEN@POSTOFFICEantispam.WORLDNET.ATT.NET
|
Viewed:
|
2378 times
|
| |
|
|
I was taking some measurements of sensors by reading the value on the
LCD display. Suddenly poof a burst of smoke came from the analog port
(0). Now the only reading I have on that port is 1, but the other ports
are fine. Could I have somehow fried the # 43 pin of the 6811. Please
advise on what I should do. There were alot of wires, so I think mabey
a wire touched a 5v output and looped it through the analog port
therefore causing a problem.
Thanks,
Peter Eacmen
--
Peter Eacmen
Boston Latin School
E-Mail:Eacmen@postoffice.worldnet.att.net
Home Page: http://www.geocities.com/Area51/Vault/2766/
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
