To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.robotics.handyboardOpen lugnet.robotics.handyboard in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / Handy Board / 185
    Re: Motor control —Tom G. Brusehaver/Consultant Euler Solutions
   (...) Depends on how far you wish IC to go. Someday there could be another controller that allows 100 disrete levels. On the other hand that could be handled well by allowing the value to go to 100, and the code written to go to 8 would be kinda (...) (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
   
        Re: Motor control —Tom Cicatelli
   (...) <snip> (...) It would make more sense to just use motor(1,speed*14) This would give you the following: Value --> Speed 0 --> 0 1 --> 14 2 --> 28 3 --> 42 4 --> 56 5 --> 70 6 --> 84 7 --> 98 I wouldn't bother rewriting the routine. Tom (29 years ago, 18-Mar-96, to lugnet.robotics.handyboard)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR