| | GP2D02 - problems?
|
|
Hi all, I used Gary Livicks routine in connection with the GP2D02 Sensor. When there is no obstacle in front of the sensor the LDC shows: "range is 77". Is that normal. Shouldn't the LCD display zero? If it is normal can you say me why? Thank you (...) (24 years ago, 19-Jul-00, to lugnet.robotics.handyboard)
|
|
| | Re: Handboard exp.
|
|
Hi, I believe an earlier post indicated that, since the analog inputs on the expansion board are multiplexed to the analog input 0 on the HB, if you cut the trace on analog port 0, the expansion board analog ports will all be "pull-up (...) (24 years ago, 20-Jul-00, to lugnet.robotics.handyboard)
|
|
| | GP2D12 on expansion board
|
|
Hi all, I am using three GP2D12 on the expansion board. When I connect them (after removing the analogue port 1 resistor and put the GP2D12 on port 24-26) I experience some weird problem. It seems the there is a short-circuit somewhere. I notice (...) (24 years ago, 19-Jul-00, to lugnet.robotics.handyboard)
|
|
| | short-circuit?
|
|
Hi, This past few days, I notice my board uses up the battery very quickly (may be because I use servos). Then I notice that the voltage regulator at U13 heats up very quickly. I was wondering if I short-circuit somewhere. I didn't build the board, (...) (24 years ago, 19-Jul-00, to lugnet.robotics.handyboard)
|
|
| | Re: What is a bobbin(sp)?
|
|
(...) is it a cylinder (about the size of 2x2) with thin wall sides? (what a lego description!) then, it is an accessory for a sewing machine that holds the thread for the backstitch. older ones are metal; newer ones are plastic. later ~ craig~ (24 years ago, 19-Jul-00, to lugnet.robotics.handyboard)
|