 | | GP2D12 on expansion board
|
|
Hi all, I am using three GP2D12 on the expansion board. When I connect them (after removing the analogue port 1 resistor and put the GP2D12 on port 24-26) I experience some weird problem. It seems the there is a short-circuit somewhere. I notice (...) (26 years ago, 19-Jul-00, to lugnet.robotics.handyboard)
|
| |
| | short-circuit?
|
|
Hi, This past few days, I notice my board uses up the battery very quickly (may be because I use servos). Then I notice that the voltage regulator at U13 heats up very quickly. I was wondering if I short-circuit somewhere. I didn't build the board, (...) (26 years ago, 19-Jul-00, to lugnet.robotics.handyboard)
|
| |
| | Re: What is a bobbin(sp)?
|
|
(...) is it a cylinder (about the size of 2x2) with thin wall sides? (what a lego description!) then, it is an accessory for a sewing machine that holds the thread for the backstitch. older ones are metal; newer ones are plastic. later ~ craig~ (26 years ago, 19-Jul-00, to lugnet.robotics.handyboard)
|
| |
| | Re: What is a bobbin(sp)?
|
|
Isn't a bobbin part of a sewing machine? I distinctly remember it being the thing underneath the needle that you needed to load with thread to make the whole thing work. Aha, a look at websters gives me the following definition: 5. (Elec.) A (...) (26 years ago, 19-Jul-00, to lugnet.robotics.handyboard)
|
| |
| | RP: GP2D12 on port 28, 29, 30
|
|
Hi. Sorry if this is a repost. I don't think I was able to post this message last time. I am thinking about putting three GP2D12 sensors on port 28, 29, 30 (because I am not thinking about using Lego Sensor, and I really like other analogue ports (...) (26 years ago, 18-Jul-00, to lugnet.robotics.handyboard)
|
