 | | Re: Motor Drivers
|
|
(...) As others have said, the system should be able to drive this. However there are some obvious 'thoughts': 1) A light that draws 300mA when running, will _momentarily_ draw a much higher value when the bulb is cold. The actual ratio between the (...) (26 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Output to file option for IC?
|
|
We have a system that was designed to let you run IC-like code on a host as if it were running on the HB. We use the HB as an extension to a larger mobile robot (the HB turns on lights, motors, etc. Our robot served candy via voice command at last (...) (26 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Output to file option for IC?
|
|
It would be cool if IC can output results to a file. well, since it can't does anyone have code available for borland c++ which will receive data over the serial port? I found some code from earlier posts, but can't seem to find one that works. I (...) (26 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Motor Drivers
|
|
300 mA shouldn't be a problem. are your main batteries low? alternately, are you sure it's 300 mA at 9v? can you measure it somehow. fred In your message you said: (...) (26 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
| |
| | Motor Drivers
|
|
I am trying to run a light with the motor outputs on the handy board. I looked up the spec on the L293D and it claims to be capable of 600mA constant and 1.2A peak. The miniature light I am using draws about 300mA. When the light comes on the handy (...) (26 years ago, 6-Apr-00, to lugnet.robotics.handyboard)
|
