 | | Re: Slower serial connection
|
|
Hi everyone! The RF tx/rx units shown on the page were from Ming Microsystems. They were rated for 1200 baud, but I've been able to transmit/receive slower using the Parallax Inc. RF boards, which were rated for 300 baud. For slower serial (...) (27 years ago, 16-Feb-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Slower serial connection
|
|
Try this web page: (URL) . It should have what you want. I have not tried it myself, but I do have the reciever/transmitter pair described on the page. (...) <excerpt><fontfamily...smaller>Is it possible to slow down the speed of the serial (...) (27 years ago, 16-Feb-00, to lugnet.robotics.handyboard)
|
| |
| | IR sensor
|
|
Hi.. does anyone know how to interface GP1u58X or IS1u60 Sharp IR sensor with handboard ?? i've tired to hack the GP1u58X from digital to analog output and plug it into analog input of HB, but the result is not good.. is there any software which can (...) (27 years ago, 16-Feb-00, to lugnet.robotics.handyboard)
|
| |
| | Re: serial output
|
|
My transmitter module can accept upto 1200 baud. can i modify this driver to run at 1200baud. if possible how? i dont really understant assembly code. could you also point me to a book or manual which gives assembler commands. many thanks M Fazal (...) (27 years ago, 16-Feb-00, to lugnet.robotics.handyboard)
|
| |
| | Slower serial connection
|
|
Is it possible to slow down the speed of the serial interface on the Handyboard? I have just gotten hold of a couple of RF transmit/receive pairs, but they are only able to go up to about 1200 baud or so. I don't intend using IC over the link, just (...) (27 years ago, 16-Feb-00, to lugnet.robotics.handyboard)
|
