 | | Re: DC motor
|
| It sounds like you might have a mechanical, rather than electrical, problem. Servos typically have some sort of stop nub on the gears so that they can't rotate past a certain point. If you don't cut off the nub with a hobby knife or saw, the motor (...) (27 years ago, 5-Feb-00, to lugnet.robotics.handyboard)
| | | | | DC motor
|
| Hello.. i am a beginner of using HB and i have some problem hope you can help me.. thanks.. I have hacked a servo motor to become a DC motor (by removing all electronic parts inside the servo) and plugged the "motor" into the motor port. but when i (...) (27 years ago, 5-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: hall effect sensors
|
| (...) Oops, I jsut realized that your question was about HB, and I was replying about Mindstorms. I don't know whether this Hall Effect sensor will work on HB. Sorry. (27 years ago, 4-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: hall effect sensors
|
| (...) Knudsen in his book (p 223) uses Digi-Key part number DN6847SE-ND, which, he says, is "sticky" in the sense that it remains set until explicitly reset. I have no experience with it. (27 years ago, 4-Feb-00, to lugnet.robotics.handyboard)
| | | | | Re: Good source for Servos
|
| (...) (27 years ago, 4-Feb-00, to lugnet.robotics.handyboard, lugnet.robotics)
|
|
