|
| | Futaba or Hitec servos
|
| Hello, Which ones are better? Advantages/Disadvantages Are there any alternatives that operate the same way? Please share some experience. Thanks for any! :) (...) This message is for the named person's use only. It may contain confidential, (...) (25 years ago, 18-Dec-99, to lugnet.robotics.handyboard)
| | | | HB heat problems, HB connectivity problems (Mac)
|
| I have two HandyBoards. One is having a severe heating problem on the second from the bottom chip on the left side. It is getting to the point that after a few minutes of being on, it is painful to touch. All of the solder points to that chip appear (...) (25 years ago, 17-Dec-99, to lugnet.robotics.handyboard)
| | | | Re: Help with IR receive
|
| thanks for the help. I just breadboarded the circuit with the RC circuit and the instability has gone away. Now I have to get the extra components on to the HB :) see the datasheet for details: (...) (25 years ago, 17-Dec-99, to lugnet.robotics.handyboard)
| | | | Shaft Encoders
|
| Can somebody provide links to Information on Shaft Encoders. Thanks Kalyan Mulampaka Software Engineer e GE Information Services ___...___ Ph#: (770) 698 4436 (O) (770) 390 0887 (R) (25 years ago, 17-Dec-99, to lugnet.robotics, lugnet.robotics.handyboard)
| | | | Re: Help with IR receive
|
| (...) substitute (...) These are NOT optional components. I saw the same thing with the IS1U60 if I didn't use the 47uf/47ohm low-pass filter on the Vdd input to the part. Use it, your problem will go away. have fun, DLC (25 years ago, 17-Dec-99, to lugnet.robotics.handyboard)
| |