 | | (no subject)
|
| unsubscribe (27 years ago, 15-Dec-99, to lugnet.robotics.handyboard)
| | | | | Re: Driving an L298 motor driver board
|
| Hi, I done a PCB with the L298 H-Bridge. You just need to remove the L293D and but a special connector in the socket. You can drive motors (2) with 2A current. If you are interesting with this PCB send me a mail. kind regards, Nicolas. (27 years ago, 14-Dec-99, to lugnet.robotics.handyboard)
| | | | | Re: error message
|
| Sorry, but Interactive C does not support the "case" construct. You'll have to rewrite your code using "if...then" statements. Ross M. Tonkens, M.D. Medical Director Primary Care of Nevada 100 North Green Valley Parkway Suite 240 Henderson, NV 89014 (...) (27 years ago, 14-Dec-99, to lugnet.robotics.handyboard)
| | | | | Re: error message
|
| Kah Mun, sorry, IC does not support the 'switch' construct. re-write using if-thens. fred In your message you said: (...) t (...) (27 years ago, 14-Dec-99, to lugnet.robotics.handyboard)
| | | | | error message
|
| Whenever I run this simple program below, i get the following error message: "Fatal Internal Error: Illegal size to spew_peek_op(read local)". What does it mean?? Please help.. void servo(char balloon) { const float left_b=400.0; const float (...) (27 years ago, 14-Dec-99, to lugnet.robotics.handyboard)
|
|
