 | | synchronization error
|
|
I'm encountering a synchronization error when calling serial_putchar within a for loop. Here's my code: void test(){ int looper; for (looper=0;looper<16;looper++){ if (looper<7){ serial_putchar(analog(looper)); printf("\nPort: %d Value: (...) (25 years ago, 7-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Another chance for the LM35
|
|
(...) Well, di you try to put an Operational Amplifier mounted in voltage following? +Vcc --- Op. Amp. | *-------* LM 35 O------|+ Vin | | | Vout|--\----- To 68HC11 Analog Port --- /-|- Vin | | GND \\\ | *-------* | \---...---/ Florent (25 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Stepper motor
|
|
Does anybody know whether it is advisable to control a 24VDC stepper motor using the handyboard's motor outputs (11V)? also, what's the maximum phase current the motor can have to be compatible with the handyboard? (25 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Stepper motor
|
|
Does anybody know whether it is advisable to control a 24VDC stepper motor using the handyboard's motor outputs (11V)? (25 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | IR files and sensors
|
|
Two question i have: 1. On the Handyboard webpage, there're the files for the IR Remote Control software. it's a little long and complicated. i'm purely interested in activating the output ports and modulating it to transmit the 40khz signal and (...) (25 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
