| | Re: before I reinvent the wheel
|
|
Doh! I should have said I was planning on using IR, but a serial cable makes more sense (at least to start with)... Thanks, Paul Adam Oliver wrote in message <001401bf04c9$2bdb67...c@adam>... I haven't actually done this, but I'm pretty sure the (...) (25 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
|
|
| | differential steering
|
|
Hi, I what to built a four wheeled robot which uses differential steering. Have somebody an idea to transfer the motion energy from the motor powered back wheels to the front wheels? Jens (25 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Re: before I reinvent the wheel
|
|
before I reinvent the wheelI haven't actually done this, but I'm pretty sure the theory is ok... On the handyboard web page is the pa79600 icb file which lets you use port a bit 7 as serial i/o. I have successfully used this to control some (...) (25 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
|
|
| | before I reinvent the wheel
|
|
Has anyone used their HP48 to talk to a handyboard? (25 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
|
|
| | Using 12V supply with Expansion Board?
|
|
Hello 'Botter, I think I am about to ask a stupid question but as a precaution, will the Expansion board be "ok" with a new 12V motor supply rather than the 9.6V connected to the Power Expansion header (J13)on the HB since the Expansion board and HB (...) (25 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
|