 | | Re: before I reinvent the wheel
|
| before I reinvent the wheelI haven't actually done this, but I'm pretty sure the theory is ok... On the handyboard web page is the pa79600 icb file which lets you use port a bit 7 as serial i/o. I have successfully used this to control some (...) (27 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
| | | | | before I reinvent the wheel
|
| Has anyone used their HP48 to talk to a handyboard? (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
| | | | | Using 12V supply with Expansion Board?
|
| Hello 'Botter, I think I am about to ask a stupid question but as a precaution, will the Expansion board be "ok" with a new 12V motor supply rather than the 9.6V connected to the Power Expansion header (J13)on the HB since the Expansion board and HB (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
| | | | | (canceled)
|
| | | | | | Re: Shaft encoder
|
| (...) The shaft encoder library routine available from the Handy Board web site works great for me. Just follow the links to Software, then Libraries, then Shaft encoders. Good luck! -- Will , , __@_/ \_@__ |/ | /__, o @_/ )\ ) ( \ (\/\\, ~~~...~~~ (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
|
|
