|
| | (canceled)
|
| | | | | Re: Shaft encoder
|
| (...) The shaft encoder library routine available from the Handy Board web site works great for me. Just follow the links to Software, then Libraries, then Shaft encoders. Good luck! -- Will , , __@_/ \_@__ |/ | /__, o @_/ )\ ) ( \ (\/\\, ~~~...~~~ (...) (25 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
| | | | RE: OVER 1 AMP
|
| You can also stack a few of the original chips to make em work in parrallel. (...) (25 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
| | | | OVER 1 AMP
|
| Oh yeah, one more thing, how about connecting a 5 ohm resistor in series with a DC motor and there are 2 amps flowing, then the resistor is dissipating 20 watts of heat. Now I could have a higher value for the resistor, like 7, 10 ohms, I think that (...) (25 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
| | | | OVER 1 AMP
|
| Thanks everyone for your help, Now, I recieved two good answers for my problems. 1) Built an H-Bridge 2) Use the LMD18200 Now has any one any documentation on an easy H bridge that I could build without wasting much time? The same goes for the (...) (25 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
| |