 | | Re: POLAROID 6500 INCONSISTENT
|
|
Bob, I do experience the same thing and taking the average does not work correctly. I compare the "distance" between the values (I have it get three) and throw out the one that is farthest away. Then I take the average of the remaining two. After (...) (25 years ago, 28-Jun-99, to lugnet.robotics.handyboard)
|
| |
| | Re: LM35 Temp Sensor
|
|
I have a couple of LM335 that I have tried to use with the miniboard. The numbers I get when converted to Fahrenheit, do not accurately represent the room temperature. The docs mention using a 10K pot to calibrate the sensor. I have not yet tried (...) (25 years ago, 28-Jun-99, to lugnet.robotics.handyboard)
|
| |
| | Baud rate of Interactive C
|
|
Hi, has anyone hacked Mac IC 3.1 to change its baud rate? I'm trying to run a radio RS232 link, and it just can't take the data at 9600 baud. Thanks, George Musser georgejr@musser.com (25 years ago, 28-Jun-99, to lugnet.robotics.handyboard)
|
| |
| | Re: IC question
|
|
Dear Victor, I'll give you a few hints about what you are trying to do. 1. the "0x" in front of 0x0e is the same as "$" in regular C. It just designates that the number following is in hex format. 2. Fred runs his motor driver chips using addresses (...) (25 years ago, 26-Jun-99, to lugnet.robotics.handyboard)
|
| |
| | LM35 Temp Sensor
|
|
Hi, Has someone tried to connect a LM35 temperature sensor to an analog input in the HB, I have had no luck with it, I have plugged it directly to the input and think that maybe is the 47K pull-up resistor the cause of the problem. Thank You José (...) (25 years ago, 26-Jun-99, to lugnet.robotics.handyboard)
|
