|
|
 | | IRPD sensors
|
| I have gotten some Infrared Proximity Detectors (IRPD), but no instructions for using them with the handyboard. These are set up with an infrared LED on each type of the sensor, and they are intended to give left/right/front detection. The program (...) (25 years ago, 14-Jun-99, to lugnet.robotics.handyboard)
| | | | | Motion sensor
|
| Hello all, Thank you for all of your kind help in the past. Here is another question that I hope is worthy of your time... I have a motion sensor purchased from Acroname (Eltec, I forget the part number). It works, as I had written a small program (...) (25 years ago, 14-Jun-99, to lugnet.robotics.handyboard)
| | | | | H-bridge
|
| Hello, Does anyone know if there is a vendor that sells a H-bridge that is ready to be used for the Handy-board, instead of me having to wire up a National Semiconductor LMD18200. Thanks for your time guys. Juergen Lunkwitz Drexel University (25 years ago, 14-Jun-99, to lugnet.robotics.handyboard)
| | | | | serial
|
| Hi, I am also having some problems with serial communications. I am trying to send information back and forth between linux and the handyboard. I wrote a simple serial sender for linux and have been trying to send to the handyboard. I have two big (...) (25 years ago, 14-Jun-99, to lugnet.robotics.handyboard)
| | | | | Re: Precision Resistor?
|
| I actually used a small 5K POT (precision, multiturn), and tuned the output for 38 KHz. Hope it helps. K.L. McKinnon (...) (25 years ago, 13-Jun-99, to lugnet.robotics.handyboard)
|
|
