 | | Motion sensor
|
| Hello all, Thank you for all of your kind help in the past. Here is another question that I hope is worthy of your time... I have a motion sensor purchased from Acroname (Eltec, I forget the part number). It works, as I had written a small program (...) (27 years ago, 14-Jun-99, to lugnet.robotics.handyboard)
| | | | | H-bridge
|
| Hello, Does anyone know if there is a vendor that sells a H-bridge that is ready to be used for the Handy-board, instead of me having to wire up a National Semiconductor LMD18200. Thanks for your time guys. Juergen Lunkwitz Drexel University (27 years ago, 14-Jun-99, to lugnet.robotics.handyboard)
| | | | | serial
|
| Hi, I am also having some problems with serial communications. I am trying to send information back and forth between linux and the handyboard. I wrote a simple serial sender for linux and have been trying to send to the handyboard. I have two big (...) (27 years ago, 14-Jun-99, to lugnet.robotics.handyboard)
| | | | | Re: Precision Resistor?
|
| I actually used a small 5K POT (precision, multiturn), and tuned the output for 38 KHz. Hope it helps. K.L. McKinnon (...) (27 years ago, 13-Jun-99, to lugnet.robotics.handyboard)
| | | | | Precision Resistor?
|
| lynneg@dbn.lia.net Hi, I'm trying to build a HandyBoard up from scratch and am having a few problems with certain parts. Very few companies sell the 3.83K presision resistor (R4) or only at an extremely high prices. Would it be possible to replace (...) (27 years ago, 13-Jun-99, to lugnet.robotics.handyboard)
|
|
