| | using IC
|
|
I'm using IC to program the Handy Board but I have run into a slight problem. How do I undefine a "main" from the board so that I can define another "main" if I can't remember the name of the window I downloaded that had the wrong "main" on it? (...) (25 years ago, 2-Jun-99, to lugnet.robotics.handyboard)
|
|
| | DINSMORE 1490 COMPASS
|
|
Hello all, If I may trouble one (or two) of you electronics gurus out there... I have a Dinsmore 1490 compass. It has twelve leads for a total of 4 sensors. I am hoping that I can at least get a rough eight point heading from this thing. I would (...) (25 years ago, 2-Jun-99, to lugnet.robotics.handyboard)
|
|
| | Sharp GP1U58 Hack without modifing my board
|
|
I have two questions. I hope someone can help. First: Is there a way to use a Sharp GP1U58 hacked to give analog values WITHOUT cutting the trace to the resistor pack on the analog inputs? Perhaps using an OP AMP. Also would removing the resistor (...) (25 years ago, 2-Jun-99, to lugnet.robotics.handyboard)
|
|
| | ICmain
|
|
I accidentally hit "download window" and it defined a "main" function onto the board. How do I undefine "main" so I can define a new one? I don't remember the name of the window I downloaded. Thanks for your help! Salpi (25 years ago, 2-Jun-99, to lugnet.robotics.handyboard)
|
|
| | Re: Ranging techniques
|
|
Bob Kelly wrote: 2). The GP2D02 works well too and is very useful in the short range.... Has anyone had any success at converting the output of this sensor to inches or some other linear unit of measure? It would be very helpful if somebody assisted (...) (25 years ago, 1-Jun-99, to lugnet.robotics.handyboard)
|