 | | IS1U60
|
|
Hi, im building the handy board and i wonder if you know some substitute for the IS1U60 infrared demodulator. Thanks a lot for you help. Sincerely yours Eduardo Gonzalez Ramirez (25 years ago, 14-May-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Servo Control Documentation Clarification...
|
|
Andre: You're right about the HandyBoard & expansion board documentation not being correct in its servo entries. I don't recall what values I found to work properly on the bare HB, but on the expansion board the default of 2540 comes close to (...) (25 years ago, 14-May-99, to lugnet.robotics.handyboard)
|
| |
| | Servo Control Documentation Clarification...
|
|
Hi, While I was trying to produce .85, 1.35, and 1.85 millisecond pulses with the Handy Board (with *and* without the expbd.), to control Team Novak's ((URL) "Super Rooster" Electronic Speed Controller (ESC), I found the following discrepancies (...) (25 years ago, 14-May-99, to lugnet.robotics.handyboard)
|
| |
| | IR routines
|
|
Hi Max: I used your IR routines with the HandyBoard. I was wondering if it is possible to do something like that for the RUG Warrior, 'cos it also uses the similar IR receiver ( GP1U52X ) . The port to which the sensor is connected is different ( (...) (25 years ago, 13-May-99, to lugnet.robotics.handyboard)
|
| |
| | MC34064
|
|
Can anybody tell me the pins config in the MC34064, because I am using the MC34064 as a susbtitute of the DS1233. Thanks Daniel ---...--- " `BETTER´ IS THE ENEMY OF `GOOD ENOUGH´" ---...--- (25 years ago, 13-May-99, to lugnet.robotics.handyboard)
|
