 | | Re: S19 disassembler
|
|
If you are looking for a *.s19 disassembler you could try the following site: (URL) (it's called a' s19 convertor') G'Luck, Ranjit (...) -- Ranjit Diol - COMPSys Dowagiac,Michigan e-mail: rsdiol@mich.com website: (URL) (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Robot base
|
|
If you're looking for a reasonably large robot base, you might want to check out "Toys 'R' Us"; there's a battery powered kid's vehicle called the "Wild Thing" at our local store for $149. It's basically about a 3 foot diameter cylinder about 1 foot (...) (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | RE: gleason research experiences?
|
|
I've bought a bunch of Handyboards and expansion boards from Gleason and have had great service and an excellent product. Barry -----Original Message----- From: Carlos Puchol [mailto:cpg@rocketmail.com] Sent: Tuesday, February 16, 1999 3:50 PM To: (...) (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | gleason research experiences?
|
|
hi i was wondering if anyone has experience ordering miniboards from gleason research. i find it odd that they do not reply to email or phone or messages for an urgent order. did we make a mistake ordering from them? any recommendations? (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Serial Communication between HBs HELP!!! (Again)
|
|
Hi, I am trying to get communication working between two HBs via the RJ11 serial port. I read the FAQ on the HB web site and I have the right cable. On the trans. HB the power LED blinks which indicates it is transmitting. Also whenever I turn on (...) (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | S19 disassembler
|
|
Will someone please point me to an S19 disassember TIA, - - - Nick - - - (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: shaft encoders for a track drive
|
|
Steve Wall wrote: <snip> (...) I've had good results using Hall effect magnetic sensors. I found some 0.1" dia. disk magnets at the hobby shop and embedded them into the holes in some Lego Technic pulley wheels. It's true that only about three (...) (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Re: sensors
|
|
Hello everyone. =) I'm currently doing research on sensors for a robot my team is building. are there such things as color sensors? any other sensor recommendations would be appreciated =) chen (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | unsubscribe
|
|
I would like to unsubscribe the mailing list Thank you (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
| |
| | Motors start when reset
|
|
Every time I reset the board, the motor port LEDs light up, if a motor is connected to the motor ports, the motors turn on. This happens until the reset is complete and I hear the beep sound. Is there a way to prevent this? Regards, ...Ameen Suleman (26 years ago, 16-Feb-99, to lugnet.robotics.handyboard)
|
