|
|
 | | Stack Overflow
|
| Hi everyone: I'm trying to download a rather large chunk of code to the HandyBoard, and I'm having a problem when I exceed a certain number of instructions in a procedure I'm running. When I try to download the code, I get the error "yacc stack (...) (26 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
| | | | | Re: senor signal line back to HD
|
| (...) The sensor should be grounded to the HB. (...) Oh yes. Quite a few messages this past week suggest how to avoid frying your sensor ports with excessive voltage. -- Will , , __@_/ \_@__ |/ | /__, o @_/ )\ ) ( \ (\/\\, ~~~...~~~ ' ` ~~~...~~~ ` (...) (26 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
| | | | | Re: Ultrasonic sensor
|
| (...) Firstly, it looks like the sensor board can be powered from the HB using the motor power header (J13). This is good, because the two should share a common ground. Based on the schematic and the web page description, it looks like this type of (...) (26 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
| | | | | Re: Toy motors
|
| sorry, send my msg before it was done. right, this is a good answer. you buy a device called an "electronic speed controller". this connects like a servo to the HB and has outputs to drive high current DC motors. you also connect a separate power (...) (26 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
| | | | | Re: Toy motors
|
| right, this is a good answer. you buy a device called an "electronic speed controller". this connects like a servo to the HB (3 wire connection) and has outputs to drive high current DC motors. you also connect a separate power supply to the device. (...) (26 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
|
|
