 | | Re: Toy motors
|
|
(...) Sure, just hack your HB to use an external battery for the motors. The external battery can be whatever voltage the motors prefer (within reason). If the motors still draw too much current, try piggybacking another set of motor driver chips on (...) (26 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | Out of TIC Inputs
|
|
Hi everyone. I'm running the HB 1.2 with the expansion board. I've installed the 6500 ranging system and use servo ports 1 through 3. I now have two wheel encoders functioning and desire to use the IC encoder routines. My problem is that I've got (...) (26 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | 6.270 vs. Handy Board motor stuff
|
|
[Max Davis] spake unto the ether: (...) Too much current (and voltage) for those original Polaroid motors, which are 6-volt. (...) I heat-sink mine with the clip-on variety; it helps. (...) I have done the 6.270 piggyback hack with the motor driver (...) (26 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | senor signal line back to HD
|
|
Hi, Currently, I'm using a infra-sensor with supply by 12v external source battery.The signal line wire is plug directly into the HD digital or analog port. The positive and negative supply of this infra-sensor is connected to the external supply (...) (26 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | Re: POWER GLITCH
|
|
(...) Please see the FAQ, specifically: (URL) I am also looking for a servro motor, any (...) Please see the "Get One" pages, specifically: (URL) (26 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
|
