 | | Out of TIC Inputs
|
| Hi everyone. I'm running the HB 1.2 with the expansion board. I've installed the 6500 ranging system and use servo ports 1 through 3. I now have two wheel encoders functioning and desire to use the IC encoder routines. My problem is that I've got (...) (28 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
| | | | | 6.270 vs. Handy Board motor stuff
|
| [Max Davis] spake unto the ether: (...) Too much current (and voltage) for those original Polaroid motors, which are 6-volt. (...) I heat-sink mine with the clip-on variety; it helps. (...) I have done the 6.270 piggyback hack with the motor driver (...) (28 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
| | | | | senor signal line back to HD
|
| Hi, Currently, I'm using a infra-sensor with supply by 12v external source battery.The signal line wire is plug directly into the HD digital or analog port. The positive and negative supply of this infra-sensor is connected to the external supply (...) (28 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
| | | | | Re: POWER GLITCH
|
| (...) Please see the FAQ, specifically: (URL) I am also looking for a servro motor, any (...) Please see the "Get One" pages, specifically: (URL) (28 years ago, 22-Jan-99, to lugnet.robotics.handyboard)
| | | | | (no subject)
|
| Hello, folks. My first foray back onto the list in a few years. I checked the archives and didn't see an answer to this question, so here goes: Until recently, I taught a freshmen robotics seminar using old 6.270 boards, motors, and parts bought (...) (28 years ago, 21-Jan-99, to lugnet.robotics.handyboard)
|
|
